The LOGSELECT Procedure

DISPLAYOUT Statement

DISPLAYOUT table-spec-list </ options>;

The DISPLAYOUT statement enables you to create CAS output tables from your displayed output. This statement is similar to the ODS OUTPUT statement. For more information about ODS, see SAS Output Delivery System: Procedures Guide.

The table-spec-list specifies a list of CAS output tables to create. Each entry in the list has either a key=value format or a key format:

key=value: specifies key as the ODS table name, path, or partial pathname, and specifies value as the CAS output table name.
key: specifies key as the ODS table name and also as the CAS output table name.

The ODS table names that you can specify are listed in the section ODS Table Names. You cannot specify the ODS table named OutputCasTables in the table-spec-list.

Table names and partial pathnames are discussed under the DISPLAY statement. The DISPLAYOUT statement does not support regular expressions.

You can specify the following options after a slash (/):

INCLUDEALL: creates output CAS tables for all display tables. The name of the created output CAS table is the same as the corresponding display table name. If you specify this option, the table-spec-list specification is ignored.
NOREPLACE: does not replace any existing CAS output table of the same name.
REPEATED: replicates all CAS output tables on all nodes.

Last updated: December 21, 2018