HMM Procedure

specifies the input data table for model information. The data table must be an output data table that is produced by the OUTMODEL= option in a previous call of the HMM procedure. When you specify this option, the IN= option in the ESTIMATE statement and the ID, INITIAL, MODEL, OPTIMIZE, and PRIOR statements are ignored. libref.data-table is a two-level name, where libref refers to the library, and data-table specifies the name of the input data table. For more information about this two-level name, see the DATA= option and the section Using CAS Sessions and CAS Engine Librefs.

writes the model information to the specified output data table. The output data table consists of binary large object columns to store the binary data. Do not edit the content of this output data table. If you run the PRINT procedure on this data table, you get a row of zeros or meaningless characters because the data type of each column is binary. libref.data-table is a two-level name, where libref refers to the library, and data-table specifies the name of the output data table. For more information about this two-level name, see the DATA= option and the section Using CAS Sessions and CAS Engine Librefs.